- As before, inetd support support is turned of per default.
Code for inetd can be made with -I.
- Support for ``transport monitors'' and the NLSPROVIDER env
variable is still there , even if their use is not clear in
non TLI stream based systems like Free-/NetBSD. It can be activated
with -P.
- There are a few corrections in rpcgen.1 and usage function to conform
to the code. Added and documented -P
- I removed the #ifdefs checks for Free-/NetBSD since we are the only
ones who use this code. MaxOS X may have the same limitations as
we have, so this code will correctly build for them.
- Generate correct cflags.
Submitted by: mbr, Jean-Luc Richier <Jean-Luc.Richier@imag.fr>
PR: bin/29175, misc/27816
- always reinitialize the rx descriptors, even if the mbuf is kept.
This should fix the hangs on ifconfig that were observed
- on an rx overflow, reinitialize the descriptor so that the interface
will not hang
- correct some bus_dmamap_sync() calls
- correct some debug messages
- some minor nits
Following a suggestion by Ruslan, the initial creation of the
includes and libraries (and build tools) is now done by
invoking "make buildworld" (with -DPICOBSD which eventually will
limit the amount of stuff built with a 2-line change in Makefile.inc1).
The correct environment is then used for subsequent builds.
Also remove write_mfs_in_kernel.c in favour of using dd
All the above is conditional on __FreeBSD_version, as the previous
method still worked for versions earlier than 500035, and I am
unsure on how the "new" method works for earlier versions.
Finally, note that the crunch.conf files need some work because
some libraries (e.g. gmd) have gone away from the base installation.
1/ don't need to set td_state to TDS_RUNNING in fork_return.
it's already set in choosethread().
2/ Set a child process state to "normal" as opposed to "new"
when we allow it to be put on the run queue.
Allows child to receive signals from the parent if the parent
runs first and tries to immediatly signal he child.
Submitted by: (part 2) Thomas Moestl <tmoestl@gmx.net>
that's binary compatible for -stable. While binary compatibility doesn't
matter much in -current, it is critical for -stable. This change requires
pccardd/pccardc to be recompiled.
formulated. The correct states should be:
IDLE: On the idle KSE list for that KSEG
RUNQ: Linked onto the system run queue.
THREAD: Attached to a thread and slaved to whatever state the thread is in.
This means that most places where we were adjusting kse state can go away
as it is just moving around because the thread is..
The only places we need to adjust the KSE state is in transition to and from
the idle and run queues.
Reviewed by: jhb@freebsd.org
-finstrument-functions instead of -mprofiler-epilogue. The former
works essentially the same as the latter but has a higher overhead
(about 22 more bytes per function for passing unused args to the
profiling functions).
Removed all traces of the IDENT Makefile variable, which had been
reduced to just a place for holding profiling's contribution to CFLAGS
(the IDENT that gives the kernel identity was renamed to KERN_IDENT).
o Assert that the page queues lock is held in vm_page_unwire().
o Make vm_page_lock_queues() and vm_page_unlock_queues() visible
to kernel loadable modules.
(PROFLEVEL) to kern.pre.mk so that it is easier to manage. Bumped config
version to match.
Moved the check for cputype being configured to a less bogus place in
mkmakefile.c.
