be accessed by root. It uses unsigned ints instead of size_t
to preserve the ABI.
PR: 207627
Submitted by: ryan@ryanday.net (with slight tweaks)
MFC after: 1 month
illumos/illumos-gate@620f322510620f322510https://www.illumos.org/issues/6051
Currently lzc_receive() requires that its snapname argument is a snapshot name
(contains '@').
zfs receive allows to specify just a dataset name and would try to deduce the
snapshot name from the stream.
I propose to allow lzc_receive() to do the same.
That seems to be quite easy to implement, it requires only a small amount of
logic, it does not require any additional system calls or any additional data
from the stream.
The benefit is that the new behavior would allow to keep the snapshot names the
same between the sender and receiver at zero cost, without a need to pass the
names out of band.
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Reviewed by: Paul Dagnelie <pcd@delphix.com>
Approved by: Robert Mustacchi <rm@joyent.com>
Author: Andriy Gapon <avg@icyb.net.ua>
MFC after: 2 weeks
This change reverts most of r281985.
The method did not map to anything defined by SMBus protocol and could
not be implemented for SMBus controllers.
This change is obviously not backwards compatible, but I have good
reasons to believe that there have never been any users of SMB_TRANS.
Discussed with: grembo, jhb
MFC after: 6 weeks
To enable event sourcing from atkbd kern.evdev.rcpt_mask value
should have bit 3 set.
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D8381
The device doesn't accurately update the CHANCMP address with the device state
when the device is suspended or halted. So, read the CHANSTS register to check
for those states.
We still need to read the CHANCMP address for the last completed descriptor.
Sponsored by: Dell EMC Isilon
we never try to sleep while the thread is on a sleepqueue.
Reviewed by: jhb
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D8422
illumos/illumos-gate@620f322510620f322510https://www.illumos.org/issues/6051
Currently lzc_receive() requires that its snapname argument is a snapshot name
(contains '').
@zfs receive allows to specify just a dataset name and would try to deduce the
snapshot name from the stream.
I propose to allow lzc_receive() to do the same.
That seems to be quite easy to implement, it requires only a small amount of
logic, it does not require any additional system calls or any additional data
from the stream.
The benefit is that the new behavior would allow to keep the snapshot names the
same between the sender and receiver at zero cost, without a need to pass the
names out of band.
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Reviewed by: Paul Dagnelie <pcd@delphix.com>
Approved by: Robert Mustacchi <rm@joyent.com>
Author: Andriy Gapon <avg@icyb.net.ua>
that are apparently misconfigured by the manufacturer and cause the mapping
logic to fail. The fallback allows drive numbers to be assigned based on the
PHY number that they're attached to. Add sysctls and tunables to overrid
this new behavior, but they should be considered only necessary for debugging.
Reviewed by: imp, smh
Obtained from: Netflix
MFC after: 3 days
Sponsored by: D8403
(it takes a long time on systems with many interfaces)
without reason and without checking its return value.
Reviewed by: cem
Obtained from: Maryse Levavasseur <maryse.levavasseur@stormshield.eu>
MFC after: 1 month
Sponsored by: Stormshield
Differential Revision: https://reviews.freebsd.org/D6979
* Rename ARM_HAVE_MP_EXTENSIONS to ARM_USE_MP_EXTENSIONS and extend it to
handle more cases, including when SMP is not enabled.
* Check ARM_USE_MP_EXTENSIONS when building for ARMv7+, even if no SMP.
* Use ARM_USE_MP_EXTENSIONS in pmap-v6.c to detect when to set PRRR_NS1.
With this we should be able to boot on all ARMv7+ Cortex-A cores with
32-bit support.
Reviewed by: mmel, imp (earlier version)
Relnotes: yes
Sponsored by: ABT Systems Ltd
Differential Revision: https://reviews.freebsd.org/D8335
If dotdot lookup does not escape from the file descriptor passed as
the lookup root, we can allow the component traversal. Track the
directories traversed, and check the result of dotdot lookup against
the recorded list of the directory vnodes.
Dotdot lookups are enabled by sysctl vfs.lookup_cap_dotdot, currently
disabled by default until more verification of the approach is done.
Disallow non-local filesystems for dotdot, since remote server might
conspire with the local process to allow it to escape the namespace.
This might be too cautious, provide the knob
vfs.lookup_cap_dotdot_nonlocal to override as well.
Idea by: rwatson
Discussed with: emaste, jonathan, rwatson
Reviewed by: mjg (previous version)
Tested by: pho (previous version)
Sponsored by: The FreeBSD Foundation
MFC after: 2 week
Differential revision: https://reviews.freebsd.org/D8110
process of being unmounted. Previously it would skip them, even if the
unmount eventually failed eg due to the filesystem being busy.
This behaviour broke autounmountd(8) - if you tried to manually unmount
a mounted filesystem, using 'automount -u', and the autounmountd attempted
to refresh the filesystem list in that very moment, it would conclude that
the filesystem got unmounted and not try to unmount it afterwards.
Reviewed by: kib@
Tested by: pho@
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D8030
While I'm here, move message status codes to hv_utilreg.h, since they
will be used by the upcoming VSS stuffs.
Submitted by: Hongjiang Zhang <honzhan microsoft com>
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8391
Unregister the KEXINIT handler after message has been received.
Otherwise an unauthenticated peer can repeat the KEXINIT and cause
allocation of up to 128MB -- until the connection is closed.
Reported by shilei-c at 360.cn
Obtained from: OpenBSD
lsdev should display detailed information about net devices only with -v
switch. This will make EFI and BIOS version of the loader to have the
same behavior.
Reviewed by: bapt, imp
Approved by: imp (mentor)
Differential Revision: https://reviews.freebsd.org/D8415
With guest trackpoint present trackpoint probing switched synaptics
device to absolute mode with different protocol instead of keeping it
in relative mode.
PR: 213757
Submitted by: Vladimir Kondratyev <wulf@cicgroup.ru>
MFC after: 1 week
Summary:
i.MX5 and PowerPC use a very similar eSDHC controller, which is also
similar to the uSDHC controller used by i.MX6. The imx_sdhci driver works
almost completely with PowerPC, with some minor tweaks.
There is one caveat with this: reset currently does not work on PowerPC, so has
been #ifdef'd out until this can be tracked down and fixed. If resets are done
the controller will timeout all data transactions. Without a reset, it appears
to work just fine.
This is part 3, following up r308186 and r308187.
Test Plan:
This has been tested on a PowerPC QorIQ P1022 board. It has not been
tested on i.MX, but no regressions are expected.
Reviewed By: imp
Differential Revision: https://reviews.freebsd.org/D8407
Some controllers (namely Freescale's eSDHC, tested) will continue to assert
the card removed or card insert interrupts even after being handled. To work
around this, disable watching the interrupt that just occurred until the
opposite interrupt is triggered.
Linux has a similar change in its driver to address the same problem.
* Starting a scan from wpa_supplicant or via ifconfig while associated,
should no longer cause firmware panics or abort early.
Tested:
* AC7260, STA mode
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8412
* SYNC_RESP_STRUCT and SYNC_RESP_PTR originate from the OpenBSD version of
iwm, and they weren't serving any real purpose in the FreeBSD port.
* We just do a single bus_dmamap_sync for syncing the complete received frame,
instead of explicitly bus_dmamap_sync-ing subranges of the frame like in
the OpenBSD iwm code.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D7939
Running `make libfoo.ll` or `make libfoo.bc` within a library directory
will now give us an LLVM IR version of the library, and `make foo.full.ll`
or `make foo.full.bc` will give us an IR version of a binary.
As part of this change, we add an LLVM_LINK variable to sys.mk that can be
specified/overridden using an external toolchain.
Reviewed by: bdrewery, brooks
Approved by: rwatson (mentor)
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D8388
This allows us to make strong assertions about descriptor address
validity. Additionally, future generations of the ioat(4) hardware will
require contiguous descriptors.
Reviewed by: markj
Sponsored by: Dell EMC Isilon
This paves the way for a contiguous descriptor array.
A contiguous descriptor array has the benefit that we can make strong
assertions about whether an address is a valid descriptor or not. The
other benefit is that future generations of I/OAT hardware will require
a contiguous descriptor array anyway. The downside is that after system
boot, big chunks of contiguous memory is much harder to find. So
dynamic scaling after boot is basically impossible.
Reviewed by: markj
Sponsored by: Dell EMC Isilon
for dummynet, use the correct argument for that, remove the false coment
about the presence of struct ifnet.
Fixes the input match of dummynet l2 rules.
Obtained from: pfSense
MFC after: 2 weeks
Sponsored by: Rubicon Communications, LLC (Netgate)
