the internal interrupt sources as active-high. The internal interrupt
sources are disabled when programmed as active-low.
Note that the internal interrupts have no sense bit like the external
interrupts. We program them as edge-triggered to make sure we write a
0 value to a reserved register. It does not in any way say anything
about the sense of internal interrupt.
CPUs by default, and provide a functional version of BUS_BIND_INTR().
While here, fix some potential concurrency problems in the interrupt
handling code.
ABI specifies the DF should be zero, and newer compilers do not clear
DF before using DF-sensitive instructions.
The DF clearing for signal handlers was done some time ago.
MFC after: 1 week
PTE flag cleanup from http://svn.freebsd.org/base/user/jmallett/octeon
- Rename PTE_xx flags to match their MIPS names
- Use the new pte_set/test/clear macros uniformly, instead of a mixture
of mips_pg_xxx(), pmap_pte_x() macros and direct access.
- Remove unused macros and defines from pte.h and pmap.c
Discussed on freebsd-mips@
Approved by: rrs(mentor), jmallett
wrong side into account.
* sctp_findassociation_ep_addr() must check the local address if available.
This fixes a bug where ABORT chunks were accepted even in the case where
the local was not owned by the endpoint.
Thanks to brucec for pointing out a bug in my first version of the fix.
MFC after: 3 days
extract distributions once. If a distribution fails to fetch/extract
and the user doesn't want to retry, abort the installation.
Reviewed by: randi
Approved by: rrs (mentor)
MFC after: 1 month
a getty on the serial port so that it's possible to login when the system is
rebooted.
PR: bin/23098
Submitted by: Doug Ambrisko <ambrisko at whistle.com>
Reviewed by: randi
Approved by: rrs (mentor)
MFC after: 1 month
get_fpcontext(), and npxsetuserregs() for set_fpcontext). Also,
note that usercontext is not initialized anymore in fpstate_drop().
Systematically replace references to npxgetregs() and npxsetregs()
by npxgetuserregs() and npxsetuserregs() in comments.
Noted by: bde
removal, MFi386 r209198:
Use critical sections instead of disabling local interrupts to ensure
the consistency between PCPU fpcurthread and the state of FPU.
Reviewed by: bde
Tested by: pho
believed that all 486-class CPUs FreeBSD is capable to run on, either
have no FPU and cannot use external coprocessor, or have FPU on the
package and can use #MF.
Reviewed by: bde
Tested by: pho (previous version)
FPU registers for copying. Remove the switch table and jumps from
bcopy/bzero/... to the actual implementation.
As a side-effect, i486-optimized bzero is removed.
Reviewed by: bde
Tested by: pho (previous version)
properly short terminate their transfers. This fixes a problem where input
appears several seconds late.
Reported by: Alexander Yerenkow
Submitted by: Hans Petter Selasky
HPET to steal IRQ0 from i8254 and IRQ8 from RTC timers. It can be suitable
for HPETs without FSB interrupts support, as it gives them two unshared
IRQs. It allows them to provide one per-CPU event timer on dual-CPU system,
that should be suitable for further tickless kernels.
To enable it, such lines may be added to /boot/loader.conf:
hint.atrtc.0.clock=0
hint.attimer.0.clock=0
hint.hpet.0.legacy_route=1
- Use err/errx only when the case is really fatal. For other
cases, fall back to full fsck instead of quiting fsck.
- Plug a memory leak.
- Avoid divide by zero when printing summary.
- Output "FILE SYSTEM IS MARKED CLEAN" when a successful
journal recovering is done.
- When -f is specified, do full fsck instead of journal recovery.
vm_pageout_clean(). When iterating over a range of pages, these functions
can be cheaper than vm_page_lookup() because their implementation takes
advantage of the vm_object's memq being ordered.
Reviewed by: kib@
MFC after: 3 weeks
Move code that converts params from humanized numbers to sectors count
to subr.c and adjust comment.
Add post-processing for "size" and "start offset" params in gpart,
now they are properly converted to sectors count with known sector size
that can be greater that 512 bytes.
Also replace "unsigned long long" type to "off_t" for unify code since
it used for medium size in libgeom(3) and DIOCGMEDIASIZE ioctl.
PR: bin/146277
Reviewed by: marcel (previous version)
Approved by: kib (mentor)
MFC after: 1 month
writing event timer drivers, for choosing best possible drivers by machine
independent code and for operating them to supply kernel with hardclock(),
statclock() and profclock() events in unified fashion on various hardware.
Infrastructure provides support for both per-CPU (independent for every CPU
core) and global timers in periodic and one-shot modes. MI management code
at this moment uses only periodic mode, but one-shot mode use planned for
later, as part of tickless kernel project.
For this moment infrastructure used on i386 and amd64 architectures. Other
archs are welcome to follow, while their current operation should not be
affected.
This patch updates existing drivers (i8254, RTC and LAPIC) for the new
order, and adds event timers support into the HPET driver. These drivers
have different capabilities:
LAPIC - per-CPU timer, supports periodic and one-shot operation, may
freeze in C3 state, calibrated on first use, so may be not exactly precise.
HPET - depending on hardware can work as per-CPU or global, supports
periodic and one-shot operation, usually provides several event timers.
i8254 - global, limited to periodic mode, because same hardware used also
as time counter.
RTC - global, supports only periodic mode, set of frequencies in Hz
limited by powers of 2.
Depending on hardware capabilities, drivers preferred in following orders,
either LAPIC, HPETs, i8254, RTC or HPETs, LAPIC, i8254, RTC.
User may explicitly specify wanted timers via loader tunables or sysctls:
kern.eventtimer.timer1 and kern.eventtimer.timer2.
If requested driver is unavailable or unoperational, system will try to
replace it. If no more timers available or "NONE" specified for second,
system will operate using only one timer, multiplying it's frequency by few
times and uing respective dividers to honor hz, stathz and profhz values,
set during initial setup.
IBAT entry in early boot in order to prevent possible faults from races
between the instruction cache and the MMU.
PR: powerpc/148003
MFC after: 3 days
the kernel compiled with QUOTA option. ufs_accessx() upgrades the vdp
vnode lock from shared to exclusive to assign the dquot structure to
the vnode, and ufs_delete_denied() is called when tvp is locked. Since
upgrade drops shared lock when non-blocked upgrade failed, LOR is there.
Reported and tested by: Dmitry Pryanishnikov <lynx.ripe gmail com>
Tested by: pho
PR: kern/147890
MFC after: 1 week
