The PCI mapping requires to know the PCI driver to use,
even before the probing is done. That's why the PCI driver is
referenced early inside the PCI device structure. See
commit 1d20a073fa ("bus/pci: reference driver structure before mapping")
However the rte_driver does not need to be referenced in rte_device
before the device probing is done.
By moving back this assignment at the end of the device probing,
it becomes possible to make clear the status of a rte_device.
Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
Reviewed-by: Andrew Rybchenko <arybchenko@solarflare.com>
Tested-by: Andrew Rybchenko <arybchenko@solarflare.com>
Reviewed-by: Rosen Xu <rosen.xu@intel.com>
The helper rte_eth_dma_zone_reserve() is called by PMDs
when probing a new port.
It creates a new memzone with an unique name.
The name of this memzone was using the name of the driver
doing the probe.
In order to avoid assigning the driver before the end of the probing,
the driver name is removed from these memzone names.
The ethdev name (data->name) is not used because it may be too long
and may be not set at this stage of probing.
Syntax of old name: <driver>_<ring>_<port>_<queue>
Syntax of new name: eth_p<port>_q<queue>_<ring>
Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
Tested-by: Andrew Rybchenko <arybchenko@solarflare.com>
The function mlx5_dev_to_port_id() is returning all the ports
associated to a rte_device.
It was comparing driver names while already comparing rte_device pointers.
If two devices are the same, they will have the same driver.
So the useless driver name comparison is removed.
Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
Acked-by: Shahaf Shuler <shahafs@mellanox.com>
With the enabling for hotplug on multi-process,
rte_eth_dev_pci_generic_remove can be used to detach the device from
a secondary process also. But we need to take care of the uninit callback
parameter to make sure it handles the secondary case correctly.
Signed-off-by: Qi Zhang <qi.z.zhang@intel.com>
Attach port from secondary should ignore devargs since the private
device is not necessary to support. Also previously, detach port on
a secondary process will mess primary process and cause the same
device can't be attached back again. A secondary process should use
rte_eth_dev_release_port_secondary to release a port.
Signed-off-by: Qi Zhang <qi.z.zhang@intel.com>
This patch adds the support to update the mbuf vlan tci field
from the HW parse results in annotation area.
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
Earlier the tx queue data was getting cleaned up in close
while rest of the functionality was in un-init.
Now a new func is created to free queue memory.
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
various field of FD structure was getting reset in scattered
fashion. This patch align them in single macro.
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
This patch copies the flc based hw provided hash results
to the mbuf rss field for lx2 platform only.
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
For now, only the packet count stats per queue is available. This is
part of xstats output (though, per queue stats are actually part of
rte_eth_stats basic stats).
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
Firmware would contain pre-configured devices for each DPMAC backing
a DPNI. This patch reads those MAC address when the device is
initialized and sets it. THereafter, it can be changed through API or
commands from testpmd.
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
In case of LX2 we get parse result summary in FD. We do not need to
prefetch and read the annotation to fetch the parse results.
Signed-off-by: Nipun Gupta <nipun.gupta@nxp.com>
This patch add the support for new Management Complex
Firmware version to 10.1x.x. One of the main changes in
the APIs ordered queue.
The fslmc bus lib ABI will need to be bumped to reflect
the MC FW API and structure changes.
This will also result in bumping of ABI verion of all dependent
libs as they internally use the MC FW APIs and structures.
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
Enable the VLAN filters only when requested in rx offload.
Fixes: 0ebce6129b ("net/dpaa2: support new ethdev offload APIs")
Cc: stable@dpdk.org
Signed-off-by: Hemant Agrawal <hemant.agrawal@nxp.com>
The code was incorrectly using the Virtual mode, whent
the IOVA mode was set as Physical.
Fixes: 5ae1edff68 ("dpaa2: prepare for 32-bit build")
Cc: stable@dpdk.org
Signed-off-by: Nipun Gupta <nipun.gupta@nxp.com>
With this patch, fslmc bus and ethernet devices on this bus
would start using the physical-virtual library interfaces.
This patch impacts mempool/dpaa2, event/dpaa2, net/dpaa2,
raw/dpaa2_cmdif and raw/dpaa2_qdma as they are dependent
on the bus/fslmc and thus impact linkage of libraries.
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
With this patch, dpaa bus and ethernet devices on this bus
would start using the physical-virtual library interfaces.
This patch impacts mempool/dpaa, event/dpaa and net/dpaa as
they are dependent on the bus/dpaa and thus impact linkage of
libraries.
Signed-off-by: Shreyansh Jain <shreyansh.jain@nxp.com>
Add rte flow flush api for flushing
all the flows of the port.
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Acked-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Added support for parsing raw flow item.
flow_item_raw_preprocess() is added for the same.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
pmd_flow_destroy() API is added to destroy the
created flow.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
pmd_flow_create API is added to support
rte flow create.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Added validation and mapping of flow rule action
with table action profile.
Added flow_rule_action_get() to do the same.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Support for validating and mapping flow rule with HASH
table match is added.
As part of this, below helper functions are added.
flow_rule_match_hash_get()
hash_key_mask_is_same()
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Support for validating and mapping rte flow rule with
ACL table match is added.
As part of this support below utility functions
been added
flow_rule_match_get()
flow_rule_match_acl_get()
flow_item_skip_disabled_protos()
flow_item_proto_preprocess()
flow_item_is_proto()
flow_item_raw_preprocess()
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Start adding flow api operations.
Started with flow validate api support by adding
below basic infrastructure.
flow_pipeline_table_get()
pmd_flow_validate()
Additional flow validate changes will be
added in next patches.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Add utility function to get the rte_eth_dev from
a given softnic.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Added utility function to freeup the
pipeline tables.
Added utility functions to find the pipeline
output port.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Change dev_name, action_profile_name and key_mask
from char* type to arary type of structures
softnic_port_in_params, softnic_port_out_params
and softnic_table_hash_params.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
Added new cli by which user can specify to softnic
which rte flow group and direction has to mapped to
which pipeline and table.
Signed-off-by: Cristian Dumitrescu <cristian.dumitrescu@intel.com>
Signed-off-by: Reshma Pattan <reshma.pattan@intel.com>
