is not going to recover until the system is reset. Treat it as a special
case and don't allow it to fall through to quasi-success.
Reviewed by: ken, imp
Obtained from: Netflix
MFC after: 3 days
the components are reset). Therefore retries are pointless. This is very
visible in SATL systems, for example an LSI SAS controller and a SATA HDD/SSD.
Reviewed by: ken
Obtained from: Netflix
MFC after: 3 days
Bay Trail has three banks of GPIOs exposed to userland as /dev/gpiocN,
where N is 1, 2, and 3. Pins in each bank are pre-named to match names
on boards schematics: GPIO_S0_SCnn, GPIO_S0_NCnn, and GPIO_S5_nn.
Controller supports edge-triggered and level-triggered interrupts but
current version of the driver does not have interrupts support
Requests which cannot be satisfied by allocators at boot time often
have unrealizable parameters. Waiting for the pagedaemon' start would
hang the boot if done in the thread0 context and just never succeed if
executed from another thread. In fact, for very early stages, sleep
attempt panics with obscure diagnostic about the scheduler state, and
explicit panic in vm_wait() makes the investigation much shorter by
cut off the examination of the thread and scheduler.
Theoretically, some subsystem might grab a resource to exhaustion, and
free it later in the boot process. If this unlikely scenario does
appear for real, the way to diagnose the trouble can be revisited.
Reported by: emaste
Reviewed by: markj
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D8421
The audio controller in the H3 is more or less the same as A10/A20 except
some registers are shuffled around. The mixer interface, however, is
completely different between SoCs. Separate a10_mixer_class and
h3_mixer_class implementations are now made available. This will also make
adding support for other SoCs easier in the future.
Reviewed by: andrew, ganbold
Relnotes: yes
Differential Revision: https://reviews.freebsd.org/D8425
they shouldn't be.
I used this during driver bring-up to find that the Linux driver holds a
whole lot of locks whilst doing their equivalent of busdma operations.
If this works out well, it should be added to the other architecture busdma
implementations to aid in similar debugging.
Tested:
* bounce buffer and dmar busdma, Lenovo X230 laptop, all the internal
hardware
* ath(4) too
Discussed with: jhb
This is a long time coming. The general pieces have been floating around
in a local repo since circa 2012 when I dropped the net80211 support
into the tree.
This allows the per-chain RSSI and NF to show up in 'ifconfig wlanX list sta'.
I haven't yet implemented the EVM hookups so that'll show up; that'll come
later.
Thanks to Susie Hellings <susie@susie.id.au> who did the original work
on this a looong time ago for a company we both worked at.
Now that the changes to the dirname(3) function had some time to settle,
let's go ahead and use the same approach for replacing basename(3) by a
simple implementation that modifies the input string, thereby making it
thread-safe and guaranteed to succeed.
Unlike dirname(3), this function already had a thread-safe variant
basename_r(3). This function had its own set of problems, like having an
upper bound on the pathname length. Keep this function around for
compatibility, but remove most references from the man page. Make the
man page more similar to that of dirname(3).
As the basename_r(3) function is only provided by FreeBSD (and Bionic),
depending on its use is even more implementation defined than assuming
that basename(3) is thread-safe.
Reviewed by: emaste
Differential Revision: https://reviews.freebsd.org/D8382
be accessed by root. It uses unsigned ints instead of size_t
to preserve the ABI.
PR: 207627
Submitted by: ryan@ryanday.net (with slight tweaks)
MFC after: 1 month
illumos/illumos-gate@620f322510620f322510https://www.illumos.org/issues/6051
Currently lzc_receive() requires that its snapname argument is a snapshot name
(contains '@').
zfs receive allows to specify just a dataset name and would try to deduce the
snapshot name from the stream.
I propose to allow lzc_receive() to do the same.
That seems to be quite easy to implement, it requires only a small amount of
logic, it does not require any additional system calls or any additional data
from the stream.
The benefit is that the new behavior would allow to keep the snapshot names the
same between the sender and receiver at zero cost, without a need to pass the
names out of band.
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Reviewed by: Paul Dagnelie <pcd@delphix.com>
Approved by: Robert Mustacchi <rm@joyent.com>
Author: Andriy Gapon <avg@icyb.net.ua>
MFC after: 2 weeks
This change reverts most of r281985.
The method did not map to anything defined by SMBus protocol and could
not be implemented for SMBus controllers.
This change is obviously not backwards compatible, but I have good
reasons to believe that there have never been any users of SMB_TRANS.
Discussed with: grembo, jhb
MFC after: 6 weeks
To enable event sourcing from atkbd kern.evdev.rcpt_mask value
should have bit 3 set.
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D8381
The device doesn't accurately update the CHANCMP address with the device state
when the device is suspended or halted. So, read the CHANSTS register to check
for those states.
We still need to read the CHANCMP address for the last completed descriptor.
Sponsored by: Dell EMC Isilon
we never try to sleep while the thread is on a sleepqueue.
Reviewed by: jhb
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D8422
illumos/illumos-gate@620f322510620f322510https://www.illumos.org/issues/6051
Currently lzc_receive() requires that its snapname argument is a snapshot name
(contains '').
@zfs receive allows to specify just a dataset name and would try to deduce the
snapshot name from the stream.
I propose to allow lzc_receive() to do the same.
That seems to be quite easy to implement, it requires only a small amount of
logic, it does not require any additional system calls or any additional data
from the stream.
The benefit is that the new behavior would allow to keep the snapshot names the
same between the sender and receiver at zero cost, without a need to pass the
names out of band.
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Reviewed by: Paul Dagnelie <pcd@delphix.com>
Approved by: Robert Mustacchi <rm@joyent.com>
Author: Andriy Gapon <avg@icyb.net.ua>
that are apparently misconfigured by the manufacturer and cause the mapping
logic to fail. The fallback allows drive numbers to be assigned based on the
PHY number that they're attached to. Add sysctls and tunables to overrid
this new behavior, but they should be considered only necessary for debugging.
Reviewed by: imp, smh
Obtained from: Netflix
MFC after: 3 days
Sponsored by: D8403
(it takes a long time on systems with many interfaces)
without reason and without checking its return value.
Reviewed by: cem
Obtained from: Maryse Levavasseur <maryse.levavasseur@stormshield.eu>
MFC after: 1 month
Sponsored by: Stormshield
Differential Revision: https://reviews.freebsd.org/D6979
* Rename ARM_HAVE_MP_EXTENSIONS to ARM_USE_MP_EXTENSIONS and extend it to
handle more cases, including when SMP is not enabled.
* Check ARM_USE_MP_EXTENSIONS when building for ARMv7+, even if no SMP.
* Use ARM_USE_MP_EXTENSIONS in pmap-v6.c to detect when to set PRRR_NS1.
With this we should be able to boot on all ARMv7+ Cortex-A cores with
32-bit support.
Reviewed by: mmel, imp (earlier version)
Relnotes: yes
Sponsored by: ABT Systems Ltd
Differential Revision: https://reviews.freebsd.org/D8335
If dotdot lookup does not escape from the file descriptor passed as
the lookup root, we can allow the component traversal. Track the
directories traversed, and check the result of dotdot lookup against
the recorded list of the directory vnodes.
Dotdot lookups are enabled by sysctl vfs.lookup_cap_dotdot, currently
disabled by default until more verification of the approach is done.
Disallow non-local filesystems for dotdot, since remote server might
conspire with the local process to allow it to escape the namespace.
This might be too cautious, provide the knob
vfs.lookup_cap_dotdot_nonlocal to override as well.
Idea by: rwatson
Discussed with: emaste, jonathan, rwatson
Reviewed by: mjg (previous version)
Tested by: pho (previous version)
Sponsored by: The FreeBSD Foundation
MFC after: 2 week
Differential revision: https://reviews.freebsd.org/D8110
