- remove pci related code from bus_space_rmi.c, we will have another
file for PCI bus space functions which will do byte-swapping.
- remove local SWAP implementation
- added TODO stub for unimplemented functions
Obtained from: C. Jayachandran - c.jayachandran@gmail.com
- (cleanup) remove rmi specific 'struct mips_intrhand' - this is no
longer needed since 'struct intr_event' have all the required hooks
- add xlr_cpu_establish_hardintr, which has args for pre/post ithread
and filter hooks, so that the PCI code can add the PCI controller
interrupt ack code here
- make 'cpu_establish_hardintr' use the above function.
- (fix) change type of eirr/eimr from register_t to uint64_t. These
have to be 64bit otherwise we cannot handle interrupts from 32.
- (fix) use eimr to mask eirr before checking interrupts, so that we
will not handle masked interrupts.
Obtained from: C. Jayachandran - c.jayachandran@gmail.com
have code that detects this and makes two
transmit descriptors. However its possible
that the algorithm detects when the second
page is not used (when the data aligns perfectly
to the bottom of the page). This caused a 0
len descriptor to be added which locks up the
rge device. Skip such things with a continue.
JC provided this patch... Thanks JC :-)
Obtained from: JC (c.jayachandran@gmail.com)
above 4Gig. If so when we add the base address with
the size we will wrap. So for now we just ignore
such memory and only use what we can. When we
get 64 bit working then we will be much better ;->
Basically the msg ring interrupt was being re-enabled
inside a spinlock as the thread set it self up for rescheduling.
This won't work since inside the re-enable is another
spin lock.. which means on return from the reenable
the interrupts have been reenabled. Thus you would
get a clock int and end up panicing holding a spin
lock to long :-o
Copy sys/dev/rmi to sys/mips/rmi/dev [sic]. For devices that are on
only one SoC, or family of SoC, we place them under sys/<vendor>/dev.
I'll fix the build problems this causes as best I can since rmi kernel
require external toolchains due to lack of support for rmi op-codes in
the ancient binutils we have in the tree.
original codes (I had changed one by accident)
Also do the pic_ack/pic_delayed_ack after the interrupt
so we clear it. The clock with these changes starts working.
Its off doing a short/long short/long warning but it
now runs.
My NFS mount now works but has the same problem with
sbin/init (errno 8 ENOEXEC) so it panics with no init.
Either this is a problem with my buildworld.. OR its a
yet undiscovered RMI issue.
the mi_startup (or to the last of it).. and
hit a panic after :
uart0: <16550 or compatible> on iodi0
Trap cause = 2 (TLB miss....)
I did have to take the pci bus OUT of the
build to get this far, hit a cache error with
the PCI code in. Interesting thing is the machine
reboots too ;-)
compile and many of them may disappear. For example
the xlr_boot1_console.c is old code that is ifdef'd out.
I will clean these sorts of things up as I make progress
on the port. So far the only thing I have I think straightened
out is the bits around the interupt handling... and hey that
may be broke ;-)
