r347241 introduced an ifname <-> kld mapping table, mostly so tun/tap/vmnet
can autoload the correct module on use. It also inadvertently made bogus
some previously valid uses of sizeof().
Revert back to ifkind on the stack for simplicity sake. This reduces the
diff from the previous version of ifmaybeload for easiser auditing.
Since the partition/slice names do vary in length, check the length
of the fixed part of the line against 3 * 8, if the lenth is less than
3 tab stops, print out extra tab.
use snprintf() instead of sprintf.
This adds initial support for RFC 2883.
Submitted by: Richard Scheffenegger
Reviewed by: rrs@
Differential Revision: https://reviews.freebsd.org/D19334
This is descrined in RFC 6582, which updates RFC 3782.
Submitted by: Richard Scheffenegger
Reviewed by: lstewart@
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D17614
lookup KPI in ip_output() like it is already used in ip_forward().
However, when there is no PCB provided we can use fast KPI, gaining
performance advantage.
Typical case when ip_output() is called without a PCB pointer is a
sendto(2) on a not connected UDP socket. In practice DNS servers do
this.
Reviewed by: melifaro
Differential Revision: https://reviews.freebsd.org/D19804
AMIs have been breaking for the past month due to insufficient disk space.
Due to the small amount of overhead in the disk image, the EC2 AMIs end
up with the same (4GB) minimum disk size.
Reported by: Michal Krawczyk
Maintain symmetry with nvme_ctrlr_create_qpairs, making it easier to
match init/uninit scenarios.
Signed-off-by: John Meneghini <johnm@netapp.com>
Submitted by: Michael Hordijk <hordijk@netapp.com>
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D19781
loaded OS.
This should prevent at least some theoretical issues whith code
execution on HT sibling of the core where the update is loaded.
Reviewed by: markj
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D20201
dme(4) is the built-in NIC on a couple non-expandable mips platforms and
thus should remain. The FCP has been updated to reflect this fact.
Discussed with: imp
when they end up being unused.
Reviewed by: kib
Obtained from: OpenBSD
MFC after: 2 weeks
Sponsored by: Klara Inc.
Differential Revision: https://reviews.freebsd.org/D20185
While phil is working on fixing in libxo general test parts, updating these
files to stop the test failure warnings
Approved by: phil
MFC with: r347207
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D20188
- there is no need to take the process lock to iterate the thread
list after single-threading is enforced
- typically there are no mutexes to clean up (testable without taking
the global umtx lock)
- typically there is no need to adjust the priority (testable without
taking thread lock)
Reviewed by: kib
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D20160
* Make mmu_booke_sync_icache() use the DMAP on 64-bit prcoesses, no need to
map the page into the user's address space. This removes the
pvh_global_lock from the equation on 64-bit.
* Don't map the page with user-readability on 32-bit. I don't know what the
chance of a given user process being able to access the NULL page when
another process's page is added there, but it doesn't seem like a good
idea to map it to NULL with user read permissions.
* Only sync as much as we need to. There are only two significant places
where pmap_sync_icache is used: proc_rwmem(), and the SIGILL second-chance
for powerpc. The SIGILL second chance is likely the most common, and only
syncs 4 bytes, so avoid the other 127 loop iterations (4096 / 32 byte
cacheline) in __syncicache().
Reduce the surface area of the TLB locks. Unfortunately the same trick for
serializing the tlbie instruction on OEA64 cannot be used here to reduce the
scope of the tlbivax mutex to the tlbsync only, as the mutex also serializes
the TLB miss lock as a side effect, so contention on this lock may not be
reducible any further.
Ampere eMAG systems have XHCI just described in ACPI, not on PCI.
Submitted by: Greg V <greg@unrelenting.technology>
Reviewed by: andrew
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D19986
Grab device reserved physical memory regions from FDT using standard
"memory-region" property and use vmem(9) to allocate buffers from it.
The same vmem could be used by DMA engine drivers to allocate memory for
DMA descriptors.
This is required for platforms that provide uncached memory region
reserved exclusively for DMA operations.
o Change sleepable sx(9) lock type to non-sleepable mutex(9) since
network drivers usually hold mutex during DMA operations. So we don't
take sleepable lock after non-sleepable.
Tested on U.S. Government Furnished Equipment (GFE) 64-bit RISC-V cores.
Sponsored by: DARPA, AFRL
Mjg@ reports that RDSEED (r347239) causes a lot of logspam from this printf,
and I don't feel that it is especially useful (even ratelimited). There are
many other quality/quantity checks we're not performing on entropy sources;
lack of high frequency availability does not disqualify a good entropy
source.
There is some discussion in the linked Differential about what logging might
be appropriate and/or polling policy for slower TRNG sources. Please feel
free to chime in if you have opinions.
Reported by: mjg
Reviewed by: markm, delphij
Approved by: secteam(delphij)
X-MFC-With: r347239
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D20195
We don't want the generator itself tagged as a generated file.
Reviewed by: cem
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D20182
There is no reason to re-create the command workqueue during healthcare.
This also fixes an issue where a previous work struct may refer to a
destroyed workqueue.
MFC after: 3 days
Sponsored by: Mellanox Technologies
Present code uses lock-less accesses to the dump data to prevent top
level ioctls from blocking bottom-level call to dump. Unfortunately, this
depends on the type stability of the dump data structure, which makes it
non-functional during driver teardown.
Switch to the mutex locking scheme where top levels use the mutex in the
bound regions, while copyouts and drain for completion utilize condvars.
The mutex lifetime is guaranteed to be strictly larger than the time
interval where driver can initiate dump, and most of the control fields
of the old struct mlx5_dump_data are directly embedded into struct
mlx5_core_dev.
Submitted by: kib@
MFC after: 3 days
Sponsored by: Mellanox Technologies
Avoid race for command completion when triggering a command completions event.
Serialize operation by queueing all commands on the same work queue.
This can happen when healthcare triggers.
MFC after: 3 days
Sponsored by: Mellanox Technologies
The command timeout is terribly long, whole two hours. Make it 60s so if
things do go wrong, the user gets feedback in relatively short time, so
they can take corrective actions and/or investigate using tools and such.
Linux commit:
6b6c07bdcdc97ccac2596063bfc32a5faddfe884
MFC after: 3 days
Sponsored by: Mellanox Technologies
Function 'mlx5e_alloc_rx_wqe' can never be inlined because it uses alloca
(override using the always_inline attribute)
MFC after: 3 days
Sponsored by: Mellanox Technologies
